++openwrt scripts

openwrt-add-camera-with-motion.sh

@@ -0,0 +1,52 @@
+#!/bin/sh
+
+if [ $# -lt 1 ]; then
+    echo "$0 ip-address"
+    echo "    ip-address: where to find the device"
+    exit 1
+fi
+
+
+set -x
+
+openwrt_ip=$1; shift
+
+ping -c3 ${openwrt_ip}
+if [ $? -ne 0 ]; then
+    echo "Cannot reach ${openwrt_ip}, aborting"
+    exit 1
+fi
+
+cat <<EOF | ssh -t "root@${openwrt_ip}"
+set -x
+
+opkg update
+opkg install motion kmod-video-uvc
+
+uci set motion.general.enabled=1
+
+cat > /etc/motion.conf <<COF
+
+ipv6_enabled on
+daemon off
+process_id_file /var/run/motion/motion.pid
+setup_mode off
+
+webcontrol_port 8080
+webcontrol_localhost on
+
+videodevice /dev/video0
+v4l2_palette 8
+
+width 1280
+height 720
+
+videodevice /dev/video0
+input -1
+stream_port 8081
+stream_localhost off
+
+COF
+
+/etc/init.d/motion restart
+EOF

openwrt-add-jool.sh

@@ -0,0 +1,32 @@
+#!/bin/sh
+
+if [ $# -ne 1 ]; then
+    echo "$0 ip-address nat64-prefix"
+    echo "    ip-address: where to find the OpenWRT device"
+    echo "    nat64-prefix: which network to use for outgoing 'ipv4' (f.i. 2a0a:e5c0:2:10::/96)"
+    echo "    ip-address: where to find the OpenWRT device"
+    exit 1
+fi
+
+my_ip=$1; shift
+nat64_prefix=$1; shift
+
+cat <<EOF | ssh -t "root@${my_ip}"
+set -x
+
+opkg update
+opkg install kmod-jool jool-tools
+
+# Depending on the interface
+sysctl -w net.ipv6.conf.wlan0.accept_ra=2
+
+modprobe jool_siit
+jool_siit -6 2a0a:e5c0:2:10::/96
+jool_siit -e -a 2a0a:e5c0:10:b01::/64 192.168.1.0/24
+
+
+
+#jool_siit -e -a 2a0a:e5c1:14d:f00d::/96 10.0.0.0/8
+
+
+EOF