import makefile from step 8

netpfga/minip4/simple_sume_switch/test/sim_switch_default/Makefile

@@ -0,0 +1,40 @@
+#
+# Copyright (c) 2017 Stephen Ibanez
+# All rights reserved.
+#
+# This software was developed by Stanford University and the University of Cambridge Computer Laboratory 
+# under National Science Foundation under Grant No. CNS-0855268,
+# the University of Cambridge Computer Laboratory under EPSRC INTERNET Project EP/H040536/1 and
+# by the University of Cambridge Computer Laboratory under DARPA/AFRL contract FA8750-11-C-0249 ("MRC2"), 
+# as part of the DARPA MRC research programme.
+#
+# @NETFPGA_LICENSE_HEADER_START@
+#
+# Licensed to NetFPGA C.I.C. (NetFPGA) under one or more contributor
+# license agreements.  See the NOTICE file distributed with this work for
+# additional information regarding copyright ownership.  NetFPGA licenses this
+# file to you under the NetFPGA Hardware-Software License, Version 1.0 (the
+# "License"); you may not use this file except in compliance with the
+# License.  You may obtain a copy of the License at:
+#
+#   http://www.netfpga-cic.org
+#
+# Unless required by applicable law or agreed to in writing, Work distributed
+# under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
+# CONDITIONS OF ANY KIND, either express or implied.  See the License for the
+# specific language governing permissions and limitations under the License.
+#
+# @NETFPGA_LICENSE_HEADER_END@
+#
+
+
+# Makefile to set up the simulation environment with the test data
+
+SDNET_BASE_ADDR=0x44020000
+
+all: clean
+	cp ${P4_PROJECT_DIR}/testdata/config_writes.py ./ 
+
+clean:
+	rm -f config_writes.py*
+	rm -f *.pyc