lorawan/sodaq_one/lora.ino

94 lines
2.6 KiB
Arduino
Raw Normal View History

2016-10-22 20:38:24 +00:00
#include <Arduino.h>
#include "Sodaq_RN2483.h"
#define loraSerial Serial1
#define beePin ENABLE_PIN_IO
#ifdef LORA_ABP
void setupLoRaABP(){
if (LoRaBee.initABP(loraSerial, devAddr, appSKey, nwkSKey, true))
{
debugSerial.println("Lora: ABP setup ok");
}
else
{
debugSerial.println("Lora: ABP setup failed");
}
}
#endif
#ifdef LORA_OTAA
void setupLoRaOTAA(){
if (LoRaBee.initOTA(loraSerial, DevEUI, AppEUI, AppKey, true))
{
debugSerial.println("Lora: OTAA setup ok");
}
else
{
debugSerial.println("Lora: OTAA Setup failed!");
}
}
#endif
void loraSetup()
{
pinMode(ENABLE_PIN_IO, OUTPUT); // ONE
digitalWrite(beePin, HIGH); // Lorawan
loraSerial.begin(LoRaBee.getDefaultBaudRate());
#ifdef LORA_OTAA
setupLoRaOTAA();
#endif
#ifdef LORA_ABP
setupLoRaABP();
#endif
}
void loraSend(String packet){
switch (LoRaBee.sendReqAck(1, (uint8_t*)packet.c_str(), packet.length(), 8))
{
case NoError:
debugSerial.println("Successful transmission.");
break;
case NoResponse:
debugSerial.println("There was no response from the device.");
loraSetup();
break;
case Timeout:
debugSerial.println("Connection timed-out. Check your serial connection to the device! Sleeping for 20sec.");
delay(20000);
break;
case PayloadSizeError:
debugSerial.println("The size of the payload is greater than allowed. Transmission failed!");
break;
case InternalError:
debugSerial.println("Oh No! This shouldn't happen. Something is really wrong! Try restarting the device!\r\nThe network connection will reset.");
loraSetup();
break;
case Busy:
debugSerial.println("The device is busy. Sleeping for 10 extra seconds.");
delay(10000);
break;
case NetworkFatalError:
debugSerial.println("There is a non-recoverable error with the network connection. You should re-connect.\r\nThe network connection will reset.");
loraSetup();
break;
case NotConnected:
debugSerial.println("The device is not connected to the network. Please connect to the network before attempting to send data.\r\nThe network connection will reset.");
loraSetup();
break;
case NoAcknowledgment:
debugSerial.println("There was no acknowledgment sent back!");
// When you this message you are probaly out of range of the network.
break;
default:
break;
}
/* Delay some time to give avoid keeping the device busy */
delay(2000);
2016-10-22 20:38:24 +00:00
}